The relationship between the Angle and Cone of Friction
View other versions (4)
Engineers often refer to either the coefficient of friction or the angle of friction. This section describes their relationship and goes on to explain the Cone of friction:
Let R be the normal reaction at a point of contact O and F the frictional force acting in a direction perpendicular to R. Then the total force at O is given by
and the magnitude of the limiting friction can be found if either or is known.
If the direction in which the body tends to move is varied the the force of limiting friction will always lie in the plane through O perpendicular to the normal reaction and the direction of the total action at O will always lie 0n a cone with it's vertex at O and axis along the line of the normal reaction. The semi vertical angle will be
This cone is called the cone of friction. If friction is not limiting, the angle made by the total action at O will be less than . Hence whether the friction be limiting or not, the direction of the total action at O must be inside or on the cone of friction. It follows that if P is the resultant of the other forces acting on the body which is in equilibrium, the direction of P must lie inside or on the cone o friction, since P must balance the total action at O
Last Modified: 2011-09-11 13:03:45 Page Rendered: 2013-05-18 08:44:57